E-service for direct driven compressors

Prolong the life of your compressor with correct maintenance and use. Install only original parts to avoid damaging the compressor

Before working on the compressor:
- Turn it off the unplug
- Empty the vessel
- Safety first! Wear gloves and check that all equipment is ready and reachable


How to set up an ABAC direct-driven air compressor.

Warning: unbox the compressor and make sure it is in perfect condition, checking if it was damaged during the transport. Carry out the operations as showed.



The compressor is fully automatic and is controlled by the pressure switch, which stops it when tank pressure reaches maximum value and restarts it when it falls below a minimum value.

Warning: Check that the mains power matches that indicated on the electrical data-plate


Vessel draining

The compressor generates condensate water which accumulates in the tank. The condensate in the tank must be drained at least once a week, by opening the drain tap under the tank.

Warning: Take care if there is compressed air inside the cylinder, and water could flow out with considerable force. Condensate of oil lubricated compressors must not be drained into the sewer or dispersed in the environment as it contains oil. Dispose of it accordingly.


Oil change

The compressor is filled with original oil. We recommend a full change of oil in the pumping element within the first 100 hours of duty.

Warning: do not drain used oil into the sewer or dispose of it in the environment.


Air filter cleaning

Every 50 hours of duty we advise you to dismantle the suction filter and clean the filtering element by blowing compressed air on it (fig. 24). You are recommended to replace the filter element at least once if the compressor operates in a clean environment, but more frequently if in a dusty environment.